LGDehome Auto Leveling Position Sensor for 3D Printer RepRap Anet A8 Prusa i3

Auto Leveling Sensor for 3D Printer

Main Features:
Compatible Model:Anet A8, Anet A6, For Prusa i3
● Detection range: 8mm
● Working voltage: DC 6 – 36V
● It is an auto leveling sensor for 3D printers. It can precisely measure the tilt of your print surface
● It can greatly improve the printing precision of your 3D printer
● For Anet A8 or other 3D printer which has the software of the automatic leveling control system
Package included: 1xAuto Leveling Position Sensor as picture shows

Product Features

  • Detection distance: 8mm
  • Working Voltage:DC 6-38V
  • Fit for: 3D Printer
  • Comes with mounting plate and pre soldered connector
  • 100% Brand new and high quality!!

Visit The Website For More Information…

What's Hot Today!

Published by

admin

3D Printing. The next Goldrush is on it´s way. Inside information on how to start printing in 3D, where to buy Printers, how to use them, and the newest Pictures and reviews of available 3D Printers.

2 thoughts on “LGDehome Auto Leveling Position Sensor for 3D Printer RepRap Anet A8 Prusa i3”

  1. Fantastic Upgrade for Anet A8 3D Printer – Required rewiring, though Upgraded my Anet A8 with this. It’s fantastic and borderline a requirement in my opinion. You do have to flash the firmware, but go on youtube and watch a couple videos – it’s super simple and can potentially be done in less than 5 minutes.I will say, much like the youtube videos have called out, that my sensor was wired incorrectly. having prepped for this upgrade, I checked the sensor’s functionality first and corrected the wiring prior to installation so I didn’t have the pain of…

  2. Great product, needed minor tooling. Excellent product, fit the description exactly. Please be aware that if you have a one of the few variations of the A8 the ground and the 5V cable may need to be swapped. Please search online to find the instructions on how to setup the auto leveling sensor with the A8 there is a ton of great info.Please also be aware you WILL need to update your firmware to either Skynet3d or similar that is scripted to use and recognize the bed leveler.The seller had great…

Leave a Reply

Your email address will not be published. Required fields are marked *

Enter Captcha Here : *

Reload Image