Gowoops MKS SBASE V1.3 3D Printer Control Board, 32bit Arm Platform Smooth Open Source MCU-LPC1768, Compatible with Smoothieware

User Guide: http://osoyoo.com/2017/01/10/mks-sbase-3d-printer-control-board-guide/

Notice:
1. Please double check it is connected to the right plus or minus before switching on the power
2. Please do not plug or unplug the motor in the case of electricity
3. Please do not adjust the current during motor operation
4. Good to work with MKS TFT touch screen(2.8” & 3.2”) and MKS LCD12864. If you use the other 12864, we can’t sure if it can work
(Can’t work with MKS MINI12864LCD, OLED12864 and LCD2004 display.)

The correct way is to disconnect the power, unplug the motor, and then re-power, adjust the potentiometer, measure the voltage on the potentiometer until the measured voltage is the same as expected.

1) MKS SBASE is a latest motherboard for 3D Printer, it is based on ARM platform and uses 32bit 100M Cortex-MS MCU-LPC1768.
2) Support highly modular open source firmware , easy for secondary development.
3) Currents of the stepper motor can be set directly, which can avoid the damage.
4) Support network function, then proceed remote control via IE Explorer. Using high quality FR-4 4 layers PCB and special design for cooling.
5) Using DRV8825 stepper driver which supports 32-microstep and with excellent cooling.
6) Using professional power chip, support 12V-24V DC input.

Package include:
1 x MKS SBASE V1.3 Board
1 x USB cable

Product Features

  • Good to work with MKS TFT28 & MKS TFT32 touch screen
  • Based on ARM platform and uses 32bit 100M Cortex-MS MCU-LPC1768
  • Support network function
  • Support 12V-24V DC input

Detailed Information available on our Homepage…

Published by

admin

3D Printing. The next Goldrush is on it´s way. Inside information on how to start printing in 3D, where to buy Printers, how to use them, and the newest Pictures and reviews of available 3D Printers.

2 thoughts on “Gowoops MKS SBASE V1.3 3D Printer Control Board, 32bit Arm Platform Smooth Open Source MCU-LPC1768, Compatible with Smoothieware”

  1. Great little screen – note that everything will be in … Excellent interface upgrade from the standard simple monochrome LCD + dial found with most 3d printer setups. Using with Marlin. The menu system is a little bit quirky but everything important is there, such as pre-heat, home, move, fan control. I’m using this with an MKS Base 1.5 board, and it’s quite simple to set up; likewise it appears it’d be straightforward to connect to ramps 1.4. Note that there are different versions of the firmware (for this touchscreen + sd reader), you’ll find…

Leave a Reply

Your email address will not be published. Required fields are marked *